Laying Methods Of Waterproof Membranes

Dec 14, 2024

Leave a message

The laying methods of waterproof membranes mainly include the following:

Cold bonding method: Use adhesive to bond the membrane to the base or between membranes.

Hot bonding method: Use heated adhesive to make the membrane fit tightly to the base.

Hot melt method: Melt the asphalt on the surface of the membrane by heating, so as to achieve a firm bond with the base.

Self-adhesive method: The membrane has its own adhesive layer, and no adhesive is required during construction, and it is directly pasted on the base.

Welding method: Applicable to polymer waterproof membranes, and the membranes are tightly connected by welding.

Mechanical fixing method: Use special fixings to fix the membrane to the base.

Construction process and precautions
Taking the self-adhesive method and wet laying method as examples, the construction process and precautions are as follows:

Self-adhesive method:

Base preparation: Make sure the base is clean, flat and dry.
‌Apply the base treatment agent‌: Use the matching base treatment agent and let it air dry until it is not sticky to the touch.
‌Laying the self-adhesive waterproofing membrane‌: Start from one end, slowly lift up the isolation paper, and pull it with appropriate force to gradually stick the entire membrane to the base. After sticking, use a rubber roller (or scraper) to forcefully roll the membrane forward and outward to expel air and ensure that it is firmly attached.
‌Sealing nodes‌: Use special sealing paste to seal relatively weak parts. ‌
‌Wet laying method‌:

‌Cleaning the base surface‌: Make sure the surface of the base is clean and flat.
‌Positioning and marking lines‌: Determine the laying position of the membrane.
‌Spreading cement slurry‌: Spread while spreading, peel off the isolation film on the lower surface of the self-adhesive waterproofing membrane, and lay it flat on the newly spread mortar.
‌Patting and pressing‌: Use a trowel or rubber board to pat and press the upper surface of the membrane to raise the slurry and expel air.
‌Sealing lap edge‌: Sealing the lap edge and the coil end, sealing, and inspection and acceptance.
Advantages and disadvantages of different paving methods and applicable scenarios
‌Cold adhesive method‌: Suitable for various environments, simple operation, but requires high-quality adhesives.
‌Hot adhesive method‌: Suitable for occasions requiring higher bonding strength, but requires heating equipment.
‌Hot melt method‌: Suitable for occasions requiring extremely high bonding strength, but requires professional equipment.
‌Self-adhesive method‌: Easy to operate, no professional equipment required, suitable for small projects.
‌Welding method‌: Suitable for polymer materials to ensure long-term waterproof effect, but requires professional welding technology.
‌Mechanical fixing method‌: Suitable for occasions requiring quick installation, but requires special fixings.

Send Inquiry